Hello
We have a MSA 2050 with 1 pool. Connected via 10GB fiber to a DL380 Gen 10 Server (2 Xeon Processors & 128GB RAM). Direct connection (no switch) Controller A1 and Controller B1 ports are connected via fiber to the back of the DL380 10GB Network Card.
This worked for a couple years. We had a data incident and I had to rebuild the Server and MSA with all new drives. Everything is setup now.
I am using iSCSI to connect the Windows 2019 DC Edition. We use this as a Hyper V Host only. The Guests are using the mapped iSCSI drive as the location of the VHDX file.
The Guests are extremly slow to respond at times. In event viewer of the Hosts I see iSCSI error messages. Guests have 4 vCPU and 16GB RAM. Just OS installed on guests. No apps yet.
Event ID 129
The description for Event ID 129 from source iScsiPrt cannot be found. Either the component that raises this event is not installed on your local computer or the installation is corrupted. You can install or repair the component on the local computer.
If the event originated on another computer, the display information had to be saved with the event.
The following information was included with the event:
\Device\RaidPort1
Event ID 39
Initiator sent a task management command to reset the target. The target name is given in the dump data.
Event ID 9
Target did not respond in time for a SCSI request. The CDB is given in the dump data.
Im affraid maybe I missed a setting from a few years ago because this setup worked great before i had to replace all the drives and setup everythging again.
Thanks